Open Access
Subscription Access
Interlaminar R-Curve Effects in Thermoplastic Composites: Experiments and Model Correlations
Abstract
The interlaminar fracture behavior of thermoplastic composites under Mode-I and Mode-II static loading is investigated in this research. The material system under consideration is a carbon fiber reinforced low melt semi-crystalline resin TC1225 LMPAEK T700G (T700/LMPAEK)†. Characterization experiments were conducted to measure the load-displacement response, peak load, and propagation of delamination from a pre-implanted Kapton® insert. The Mode-I response was characterized using a double cantilever beam (DCB) test according to the ASTM D5528-22 standard. It was observed that the propagation exhibited significant resistance to delamination growth, i.e., an R-Curve effect. The test data indicated that the steady-state fracture toughness, ? ?? ? ????, was approximately twice the mean initiation fracture toughness, ??????. The Mode-II response of an end notch flexure (ENF) specimen tested according to the ASTM D7905- 19 standard exhibited an unexpected stable behavior upon attaining peak load. Prior to attaining peak load, the Mode-II response exhibited some non-linearity, which may be attributed to nonlinear bulk material response, e.g., hyper-elasticity, viscoelasticity, plasticity, etc., and potentially friction at the load/support rollers and R-Curve effects. Finite element models based on the cohesive zone method (CZM) and the virtual crack closure technique (VCCT) were used to predict the DCB and ENF specimen responses. DCB analysis results obtained using ?????? predicted propagation consistent with experimental data. However, results obtained with the as characterized ?????? were inaccurate in predicting delamination growth onset and peak load. ENF analysis results obtained with the as-characterized Mode-II fracture toughness, ????????, were inaccurate in predicting the peak load and propagation. Hence, R-Curve effects were included in both DCB and ENF simulations, which enabled improved predictions. The experimentally determined Mode-I R-Curve was used for the DCB simulations, whereas an R-Curve was derived for Mode-II assuming that the change in compliance of the specimen was associated with crack growth only.
DOI
10.12783/asc38/36581
10.12783/asc38/36581
Full Text:
PDFRefbacks
- There are currently no refbacks.