Open Access Open Access  Restricted Access Subscription Access

BALLISTIC PERFORMANCE OF AS-PRINTED FDM COPPER-POLYMER COMPOSITE .38 SPECIAL PROJECTILES AS A RAPID PROTOTYPING MATERIAL

Avery Lyons, Parker Barnes, Phillip Mulligan

Abstract


This study evaluates the ballistic performance and pressure–velocity response of fused deposition modeling (FDM) copper–polymer composite .38 Special projectiles in the as-printed (“green”) state. Additively manufactured (AM) projectiles were fabricated from a commercial copper filled filament and compared against conventional full metal jacket (FMJ) projectiles using both revolver and universal receiver platforms. Testing included composite material characterization using optical microscopy, velocity tracking to 25 m, and terminal evaluation using soft recovery and calibrated ballistic gelatin. Results show that AM projectiles exhibit predictable velocity trends with increasing powder charge, though with greater variability due to manufacturing induced porosity and mass inconsistency. Critically, all AM projectiles remained intact after firing and impact, with no visible fragmentation or fracture. These findings support the feasibility of AM copper–polymer composites as a rapid prototyping solution. Future work will target reducing variability through improved process control, internal pressure and drag coefficients related to material, and expanding material testing to additional calibers and test conditions. Continued development of post-processes and sintering cycles to reduce oxidation and increase material densification will also be pursued.


DOI
10.12783/ballistics26/37635

Full Text:

PDF

Refbacks

  • There are currently no refbacks.