EFFECT OF VELOCITY ON THE ENGRAVING BEHAVIOR OF A CASED TELESCOPED AMMUNITION WITH A MULTI-LAYER METALLIC STRUCTURE
Abstract
Cased telescoped ammunition is a novel ammunition configuration in which the projectile is fully embedded in the cartridge case. As a result, it acquires an initial impact chambering velocity before entering the forcing cone, and variations in this velocity directly affect the engraving deformation and dynamic response of its multilayer metallic structure. To investigate this effect, a three-dimensional finite element model was established by considering large deformation, contact friction, and projectile base-pressure loading, and the engraving process under different impact chambering velocities was analyzed using an explicit dynamic method. The results show that increasing impact velocity significantly raises the stress level in the rifling-compressed region during the early stage and enlarges the initial indentation length. However, at the same displacement, the stress distribution in the engraved region remains generally similar under different conditions, whereas the stress and deformation in the projectile tail gradually decrease. The final engraved groove morphology is nearly identical for different impact velocities, but the total groove length decreases as the impact velocity increases. Dynamic analysis further indicates that, at relatively low impact velocities, the projectile remains in an overall accelerating state throughout the engraving process, whereas at higher velocities, a short deceleration followed by re-acceleration appears. Meanwhile, the engraving resistance in all cases first increases, then decreases, and finally tends to stabilize, and its peak value decreases with increasing impact velocity. These findings provide a useful reference for the structural design and engraving matching optimization of cased telescoped ammunition with multilayer metallic structures.
DOI
10.12783/ballistics26/37647
10.12783/ballistics26/37647
Refbacks
- There are currently no refbacks.