MODELING, EXPERIMENTAL VALIDATION, AND NUMERICAL SIMULATION OF JA2 DOUBLE-BASE PROPELLANT COMBUSTION IN A 700 CM3 CLOSED VESSEL BOMB USING THE POWDER BURN MODEL IN ANSYS AUTODYN
Abstract
A combined experimental and computational investigation of JA2 double-base gun propellant deflagration inside a 700 cm³ closed vessel bomb is presented. The experimental component employed a Kistler piezoelectric transducer measurement chain at a sampling rate of 100 kHz to record pressure–time (P–t) histories at a controlled loading density of Δ = 0.19 g/cm³, with the propellant charge (mp ≈ 128.1 g) prepared from 7-perforated cylindrical JA2 grains and ignited with a bridge-wire primer. Four replicate firings were performed, yielding a mean peak pressure of 105.0 ± 1.5 MPa at a time-of-peak of 54.0 ± 2.1 ms. The propellant heat of explosion was independently determined by Parr 6200 calorimetry as Qex ≈ 4.1 MJ/kg. For the numerical component, the two-phase Powder Burn equation of state implemented in ANSYS AUTODYN was employed to simulate the closed vessel deflagration event. A 2D axisymmetric model was constructed using a coupled Lagrange solver for the Steel 4340 vessel walls and a multi-material Euler solver on a 5×5 mm structured mesh for the propellant air interior. A physically justified and fully documented set of Powder Burn parameters for JA2 comprising the linear solid-phase equation of state, the exponential reacted-gas equation of state, Vieille burn-rate table H(P), Noble Abel-equivalent pressure–density gas pairs, and convective-front coefficients was derived from the experimental measurements, closed bomb literature, and thermochemical equilibrium codes. Simulation results yielded a peak pressure of 114.0 MPa at 43.0 ms, representing a relative error of +8.6% against the experimental reference. Identified discrepancies in pressurization rate and post-peak plateau are consistent with known limitations of the exponential gas EOS and the omission of conductive wall heat-transfer. The complete methodology spanning experimental characterization through AUTODYN model construction is documented in sufficient detail to facilitate direct replication and extension to gun internal-ballistics simulations of the M829-series APFSDS-T projectile fired from the 120 mm M256 smoothbore gun of the M1A1/M1A2 Abrams Main Battle Tank.
DOI
10.12783/ballistics26/37651
10.12783/ballistics26/37651
Refbacks
- There are currently no refbacks.