ASSESSMENT OF AMMUNITION GUN-LAUNCH SURVIVABILITY UTILIZING JOHNSON COOK MODELING TECHNIQUES AND SPLIT-HOPKINSON PRESSURE BAR MATERIAL DATA COLLECTION METHODS
Abstract
This paper evaluates gun-launch survivability of a critical ammunition component by comparing conventional elastic-plastic material models with Johnson–Cook (JC) strength models. Compressive JC models for 7075-T651 aluminum were developed using quasi-static and Split Hopkinson Pressure Bar (SHPB) compression tests over a range of strain rates and temperatures, with two post-processing methods used to extract JC constants. Finite element simulations in ABAQUS showed that JC models (tensile and compressive) consistently reduced the apparent margin of safety by ~6% relative to elastic-plastic analysis and altered the strain distribution within the critical component, providing insight into observed low-rate intermittent failures. The results indicated limited strain-rate sensitivity but non-trivial thermal softening behavior for this material, and demonstrated that improved calibration of the JC hardening parameters enhances representation of the gun-launch deformation state, motivating further refinement of the JC model.
DOI
10.12783/ballistics26/37705
10.12783/ballistics26/37705
Refbacks
- There are currently no refbacks.