VALIDATION OF FEA METHOD FOR PRELOAD APPLICATION IN PROJECTILES DURING GUN LAUNCH
Abstract
A series of test processes are explored to validate FEA methods for preload application of a threaded joint. The FEA method is described in a separate paper “FEA Method for Preload Application in Projectiles During Gun Launch” by Tesla, et al. The test apparatuses explored include load cells, strain gauges, ultrasonic tester, pressure tapes and high-speed cameras. The test article (TA) is loaded using the same procedure as the FEA approach. A series of test measurements are performed, starting with a torque of 625 ft-lbf (847 Nm) on the TA and gradually increased until testing limits are reached. For each preset torque value, the corresponding torque-wrench angular travel is recorded, and preload forces are measured using various test apparatuses. The recorded test data are then compared with the FEA predictions and with the results from the different measurement techniques.
DOI
10.12783/ballistics26/37707
10.12783/ballistics26/37707
Refbacks
- There are currently no refbacks.