BALLISTIC PERFORMANCE OF A THEORETICAL TUNGSTEN-CORED RIFLE CARTRIDGE COMPARED TO LEGACY RIFLE CARTRIDGES VIA FINITE ELEMENT ANALYSIS
Abstract
As defense technologies have continued to improve, there has been an increase in the importance of designing cartridges to defeat said defenses. This has led to the introduction of armor piercing (AP) cartridges into ammunition families to maintain effectiveness in combat. Materials with high sectional density, such as Tungsten, have often been used to better penetrate hardened targets. Experiments and numerical studies carried out by the US Army’s Armaments Center at Picatinny Arsenal, New Jersey, have demonstrated that if properly calibrated, modeling can be used to inform designs and note trends in ballistic performance. Finite Element impact simulations were created using IMPETUS AFEA. The target plate was modeled as Rolled Homogeneous Armor (RHA). In addition to a theoretical design, two legacy designs, M995 and M993, are being used to compare the performance. To ensure equity, the kinetic energies (KE’s) of each will be made equivalent to ensure results are not skewed unfairly.
DOI
10.12783/ballistics26/37724
10.12783/ballistics26/37724
Refbacks
- There are currently no refbacks.