TRIGGERING RADIAL BACK FACE FRACTURE OF ADDITIVELY MANUFACTURED CERAMIC TILES
Abstract
Radial fractures on the back face of three different additively manufactured silicon carbide grade samples were induced by impact of soft aluminium spheres at impact velocities ranging from 100 and 156 m/s. The analytical estimation for the critical impact velocity to trigger radial fractures in the target's back face for a given projectile-target configuration requires the target's biaxial flexural strength, which is unknown for the investigated materials. Therefore, numerical simulations combined with statistical analysis were used to provide a range of critical impact velocities. Experiments were initiated at the lower bound of this range and the impact velocity was increased incrementallly until radial fractrure initiation was observed. In parallel, the Johnson and Holmquist and bond-based Peridynamic material models implemented in LS-SYNA were employed to simulate the fracture formation and were validated against the experimental result for one of the provided grades.
DOI
10.12783/ballistics26/37725
10.12783/ballistics26/37725
Refbacks
- There are currently no refbacks.