Open Access Open Access  Restricted Access Subscription Access

NUMERICAL SIMULATION ON FORMATION CHARACTERISTICS OF COMPOSITE JET FROM BI-LAYER SHAPED CHARGE LINERS

Shouren Wang, Rui Liu, Kaiyuan Liu, Pengwan Chen

Abstract


A two-dimensional axisymmetric AUTODYN model was developed to investigate composite rod-like jet formation from Al–Cu double-layer liners. Six cases covering four liner families—conical, spherical–conical combined, spherical-cap, and eccentric spherical-cap—were simulated, and the effect of aluminum-layer thickness fraction in the spherical-cap liner was examined. Liner configuration strongly affected collapse behavior, jet morphology, and material distribution. The conical liner produced a high-velocity slender jet, whereas the spherical–conical combined liner generated the longest jet while maintaining a high jet-tip velocity. The spherical-cap liner formed a continuous rod-like jet with relatively large mass and good axial continuity. Increasing the aluminum-layer thickness fraction nonlinearly increased jet-tip velocity and jet length. At a fraction of 75%, a stable Cu-jacketed Al-core structure formed in the middle and rear jet sections, promoting favorable material distribution. These results support the optimization of Al–Cu double-layer liners and composite shaped charge jets.


DOI
10.12783/ballistics26/37698

Full Text:

PDF

Refbacks

  • There are currently no refbacks.